1 files changed, 48 insertions, 0 deletions
diff --git a/src/atariserver_slirp.sh b/src/atariserver_slirp.sh
new file mode 100755
index 0000000..c6ba620
--- /dev/null
+++ b/src/atariserver_slirp.sh
@@ -0,0 +1,48 @@
+#!/bin/sh
+
+# Configurable stuff:
+
+# Name of the disk image (default: command line arg, or fujichat.atr)
+ATR_IMAGE=${1-fujichat.atr}
+
+TTY=/dev/ttyS0         # serial port to use
+BAUD=4800              # must match FujiChat conf
+
+# This setting is only needed if you're using an AtariMax (Steve Tucker)
+# auto-sensing SIO2PC as your serial device.
+TUCKER_SIO2PC_HACK="yes"
+
+# DELAY is needed on some (most?) systems because e.g. atariserver tries
+# to run before the atarisio module is fully initialized. Choose one:
+
+# No delay:
+#DELAY="true"
+
+# 1 second:
+#DELAY="sleep 1"
+
+# 1/4 second (may not work on old Linux installs):
+DELAY="usleep 250000"
+
+# End of config section, start of code:
+
+ifconfig $SLIP_IFACE down 2&>/dev/null
+killall $SLATTACH 2&>/dev/null
+fuser -k $TTY 2&>/dev/null # make sure nobody's using the port...
+$DELAY
+fuser -k -9 $TTY 2&>/dev/null # Just in case...
+$DELAY
+modprobe atarisio port=$TTY
+$DELAY
+atariserver $ATR_IMAGE
+#atariserver autorun.sys # fails when run from MyPicoDOS, why?
+$DELAY
+rmmod atarisio
+$DELAY
+
+slirp "tty $TTY" "mru 576" "mtu 576" "baudrate $BAUD" &
+
+if [ "$TUCKER_SIO2PC_HACK" = "yes" ]; then
+	sleep 1
+	./clear_rts
+fi