blob: 8a9320a2edbb60fabdb40a159f71736f28e14597 (
plain)
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
|
#!/bin/sh
# Configurable stuff:
TTY=/dev/ttyUSB0 # serial port to use
BAUD=9600 # must match compiled-in value in rs232dev.c
SLATTACH=a8_slattach # slattach binary (possibly patched)
SLIP_IFACE=sl0 # probably no need to change this
LOCAL_IP=192.168.0.1 # SLIP IP address for Linux host
REMOTE_IP=192.168.0.2 # SLIP IP address for Atari host
IP_FORWARD=yes # Route packets for the Atari?
IP_MASQUERADE=yes # NAT for the Atari?
MASQ_IFACE=eth1 # if NATing, our main (LAM or internet) interface
DUMP_PACKETS=yes # Run tcpdump on sl0 interface?
# DELAY may not be needed on all systems...
# No delay:
#DELAY="true"
# 1 second:
#DELAY="sleep 1"
# 1/4 second (may not work on old Linux installs):
DELAY="usleep 250000"
# End of config section, start of code:
ifconfig $SLIP_IFACE down 2&>/dev/null
killall $SLATTACH 2&>/dev/null
fuser -k $TTY 2&>/dev/null # make sure nobody's using the port...
$DELAY
fuser -k -9 $TTY 2&>/dev/null # Just in case...
$DELAY
echo "Starting SLIP on $SLIP_IFACE, local $LOCAL_IP, remote $REMOTE_IP"
$SLATTACH -L -p slip -s $BAUD $TTY &
$DELAY
ifconfig $SLIP_IFACE $LOCAL_IP mtu 576
ifconfig $SLIP_IFACE $LOCAL_IP pointopoint $REMOTE_IP
if [ "$IP_MASQUERADE" = "yes" ]; then
echo "IP Masquerading enabled"
iptables -F
iptables -t nat -F
iptables -t nat -A POSTROUTING -o $MASQ_IFACE -j MASQUERADE
fi
if [ "$IP_FORWARD" = "yes" ]; then
echo "IP Forwarding enabled"
echo "1" > /proc/sys/net/ipv4/ip_forward
fi
if [ "$DUMP_PACKETS" = "yes" ]; then
tcpdump -i $SLIP_IFACE -X -n -vvv -s 0
fi
|
